IMMOBILIZER SYSTEM
8-78
Voiding the standard key code:
If a standard key has been lost, it is possible to disable its use by re-registering the remaining standard
key. Standard key registration erases the stored standard key code from the memory, thus disabling
the lost standard key. To re-register, refer to “Standard key registration”.
Standard key code voiding method
EAS27701
TROUBLESHOOTING
When the main switch is turned to “ON”, the immobilizer system indicator light does not come on nor
flashes.
NG →
OK ↓
NG →
OK ↓
NG →
OK ↓
a. Main switch “ON”
b. Main switch “OFF”
c. LED on
d. LED off
e. Less than 5.0 s
f. Code re-registering key
g. Remaining standard key
h. Registration mode
A. If the immobilizer system indicator light stops
flashing 5 seconds after the first standard key
is registered, the second standard key cannot
be registered.
1. Check the fuses.
(Main, ignition, and backup)
Refer to “CHECKING THE FUS-
ES” on page 8-133.
Replace the fuse(s).
2. Check the battery.
Refer to “CHECKING AND
CHARGING THE BATTERY” on
page 8-134.
• Clean the battery terminals.
• Recharge or replace the battery.
3. Check the main switch.
Refer to “CHECKING THE
SWITCHES” on page 8-129.
Replace the main switch/immobilizer unit.
To Next Page
Loading...
