Yamaha X Max 400 User Manual

OPERATION AND IMPORTANT RIDING POINTS
5-2
5
NOTICE
ECA15025
If a warning light, indicator light or
indicator does not go off, see pages
3-3, 3-6, 3-8, 3-8 or 3-8 for the corre-
sponding warning light, indicator
light or indicator circuit check.
2. Close the throttle completely.
3. Start the engine by pushing the
start switch while applying the
front or rear brake.
If the engine does not start, re-
lease the start switch, wait a few
seconds, and then try again. Each
starting attempt should be as
short as possible to preserve the
battery. Do not crank the engine
more than 10 seconds on any one
attempt.
NOTICE
ECA11043
For maximum engine life, never ac-
celerate hard when the engine is
cold!
EAU45093
Starting off
1. While pulling the rear brake lever
with your left hand and holding the
grab bar with your right hand,
push the scooter off the center-
stand.
2. Sit astride the seat, and then ad-
just the rear view mirrors.
3. Switch the turn signals on.
4. Check for oncoming traffic, and
then slowly turn the throttle grip
(on the right) in order to take off.
5. Switch the turn signals off.
1. Rear brake lever
2. Front brake lever
3. Start switch
1. Grab bar
U1SDE1E0.book Page 2 Monday, September 23, 2013 3:55 PM

Yamaha X Max 400 Specifications

General

Displacement	395 cc
Bore x Stroke	83.0 mm x 73.0 mm
Compression Ratio	10.6:1
Fuel System	Fuel Injection
Ignition System	TCI
Transmission	V-Belt Automatic
Front Suspension	Telescopic fork
Rear Suspension	Swingarm
Rear Brake	Hydraulic single disc, Ø 267 mm
ABS	Standard
Front Tire	120/70-15
Overall Length	2, 185 mm
Overall Height	1, 415 mm
Seat Height	800 mm
Wheelbase	1, 540 mm
Engine Type	Liquid-cooled, 4-stroke, 4-valve
Maximum Torque	36.0 Nm @ 6, 000 rpm
Rear Tire	150/70-13
Fuel Tank Capacity	13.0 liters
Front Brake	Dual hydraulic disc, 267 mm