Yamaha XLT800 WaveRunner 2003 User Manual

2-17
E
EJU01220
Engine overheat warning
system
This model is equipped with an engine
overheat warning system.
If the engine starts to overheat, the warn-
ing light, the indicator for the water tempera-
ture symbol, and “W.TEMP” display begin to
blink, the buzzer sounds, and the engine
speed will be limited to about 3,400 r/min.
When this occurs, check for water dis-
charge at the cooling water pilot outlet. If
there is no discharge of water, reduce the
engine speed and beach the watercraft, and
then check the intake grate and impeller for
clogging.
WARNING
@
Before attempting to remove weeds or
debris from the intake grate or impeller,
shut the engine off and remove the clip
from the engine shut-off switch. Severe
injury or death could result from coming
in contact with the rotating parts of the
jet pump.
@
CAUTION:
@
If you cannot locate and correct the
cause of the overheating, consult a
Yamaha dealer. Continuing to operate at
higher speeds could result in severe
engine damage.
@
N
O
TE:
@
Press any button on the multifunction meter
to stop the buzzer.
@
UF1F11.book Page 17 Monday, June 10, 2002 11:54 AM

Yamaha XLT800 WaveRunner 2003 Specifications

General

Manufacturer	Yamaha
Model	XLT800 WaveRunner
Year	2003
Category	Boat
Engine Type	2-cylinder, 2-stroke
Displacement	784 cc
Fuel Type	Gasoline
Bore x Stroke	82 x 74 mm
Starting System	Electric
Hull Material	Fiberglass
Seating Capacity	3 persons
Fuel Delivery	Carburetor