Need help?Do you have a question about the Yamaha YZ250FX 2020 and is the answer not in the manual?
General| Engine Type | Liquid-cooled, 4-stroke, DOHC, 4-valve |
|---|---|
| Displacement | 250cc |
| Bore x Stroke | 77.0mm x 53.6mm |
| Compression Ratio | 13.5:1 |
| Fuel System | Fuel Injection |
| Ignition | TCI |
| Final Drive | Chain |
| Front Brakes | Hydraulic disc, 270mm |
| Rear Brakes | Hydraulic disc, 245mm |
| Length | 85.6 in |
| Width | 32.5 in |
| Height | 50.4 in |
| Seat Height | 37.6 in |
| Ground Clearance | 12.8 in |
| Front Suspension | KYB® Speed-Sensitive System inverted fork; fully adjustable, 12.2-in travel |
| Front Tire | 80/100-21 |
| Rear Tire | 110/100-18 |
Details essential safety precautions, riding techniques, and protective apparel.
Specifications for tightening torques of various fasteners and components.
Technical specifications for the engine, including combustion, cooling, and oil systems.
Lists general and specific tightening torque values for fasteners and components.
Recommended schedule for periodic inspections and maintenance tasks.
Essential checks and maintenance before operating the vehicle for safety and performance.
Detailed procedures for checking and adjusting engine components like valve clearance and oil.
Procedures for inspecting and adjusting chassis components such as brakes, suspension, and wheels.
Procedures for checking and maintaining the vehicle's electrical system.
Detailed procedures for maintenance and repair of the front brake system.
Detailed procedures for maintenance and repair of the rear brake system.
Step-by-step instructions for safely removing the engine from the motorcycle frame.
Procedures for removing, checking, and installing the cylinder head assembly.
Procedures for removing, checking, and installing the cylinder, piston, rings, and pin.
Procedures for removing, checking, and installing the clutch assembly components.
Procedures for removing, checking, and installing the oil pump and balancer components.
Procedures for separating, disassembling, checking, and assembling the crankcase.
Procedures for removing, checking, and installing the crankshaft and balancer shaft.
Procedures for removing, checking, and installing the transmission gears, shafts, and forks.
Circuit diagram and troubleshooting for the ignition system.
Circuit diagram and troubleshooting for the electric starting system.
Circuit diagram and troubleshooting for the charging system.
Detailed troubleshooting and diagnostic information for the fuel injection system.
Diagnosing engine issues when no fault codes are present.
To Next Page