Need help?Do you have a question about the Yamaha YZF-R1 2020 and is the answer not in the manual?
General| Bore x Stroke | 79.0mm x 50.9mm |
|---|---|
| Compression Ratio | 13.0:1 |
| Fuel System | Fuel injection with YCC-T and YCC-I |
| Ignition | TCI: Transistor Controlled Ignition |
| Final Drive | Chain |
| Front Tire | 120/70ZR17 |
| Rear Tire | 190/55ZR17 |
| Wheelbase | 55.3 in |
| Seat Height | 33.7 in |
| Fuel Capacity | 4.5 gal |
| Length | 80.9 in |
| Width | 27.2 in |
| Engine Type | Liquid-cooled, 4-stroke, DOHC, 4-valve, inline 4-cylinder |
| Transmission | 6-speed |
| Frame Type | Deltabox aluminum |
| Front Suspension | 43mm KYB® inverted fork, fully adjustable; 4.7-in travel |
| Rear Suspension | KYB® single shock; adjustable preload, compression damping, and rebound damping; 4.7-in travel |
| Front Brakes | Dual 320mm hydraulic disc; ABS |
| Rear Brakes | 220mm hydraulic disc; ABS |
Details engine type, displacement, valve train, bore, stroke, compression, fuel, and oil specifications.
Covers frame type, caster angle, trail, wheel sizes, tire specifications, and brake system details.
Details system voltage, ignition system, engine control unit, charging system, and bulb wattages.
Lists tightening torques for engine and chassis components, with specific procedures for some bolts.
Step-by-step guide for measuring and adjusting valve clearance on a cold engine.
Step-by-step guide for bleeding the ABS brake system, emphasizing correct order and precautions.
Step-by-step guide for draining and refilling engine oil, including oil filter replacement.
Step-by-step guide for removing the front wheel and brake discs for YZF-R1 and YZF-R1M.
Procedure for removing the rear wheel, brake disc, and sprocket.
Covers removing front brake pads, calipers, and master cylinder.
Details removing rear brake pads, master cylinder, and caliper.
Step-by-step instructions for removing and disassembling the front fork legs.
Details removing and disassembling the front fork legs for YZF-R1M models.
Details procedures for measuring compression pressure, checking valve clearance, and engine idling speed.
Step-by-step guide for removing the engine, including muffler, exhaust pipe, and related components.
Procedure for removing, checking, and installing the cylinder head and gasket.
Covers removing, disassembling, checking, and installing connecting rods and pistons.
Provides circuit diagram and troubleshooting for ignition system failures.
Details circuit diagram and troubleshooting for starter motor failures.
Covers circuit diagram and troubleshooting for battery charging issues.
Provides circuit diagram and troubleshooting for lighting system failures.
To Next Page
