Need help?Do you have a question about the Yamaha YZ250FX 2019 and is the answer not in the manual?
General| Displacement | 250cc |
|---|---|
| Bore x Stroke | 77.0mm x 53.6mm |
| Fuel System | Yamaha Fuel Injection (YFI), Keihin® 44mm |
| Ignition | TCI: Transistor Controlled Ignition |
| Final Drive | Chain |
| Front Brake | Hydraulic disc, 270mm |
| Rear Brake | Hydraulic disc, 245mm |
| Seat Height | 37.6 in |
| Ground Clearance | 12.8 in |
| Fuel Capacity | 2.1 gal |
| Wet Weight | 249 lb |
| Engine Type | Liquid-cooled DOHC 4-stroke |
| Transmission | Wide-ratio 6-speed; multiplate wet clutch |
| Front Suspension | KYB® spring-type fork, fully adjustable |
| Rear Suspension | KYB® single shock |
| L x W x H | 32.5 in |
| Front Tire | 90/90-21 |
| Rear Tire | 110/100-18 |
Lists critical torque specifications for various components.
Details engine type, displacement, bore, stroke, compression ratio, and fuel.
Specifies general tightening torques for standard fasteners.
Outlines recommended maintenance intervals for various vehicle components.
Details pre-ride checks to ensure the machine is in good operating condition.
Covers checks and adjustments for engine-related systems.
Details procedures for removing, checking, disassembling, and assembling the front wheel.
Covers procedures for removing, checking, and assembling the rear wheel.
Details removal, disassembly, checking, and assembly of the front brake system.
Covers removal, disassembly, checking, and assembly of the rear brake system.
Covers removal, disassembly, checking, and assembly of the front fork legs.
Covers handling, removal, checking, and installation of the rear shock absorber.
Provides the procedure for removing the engine from the vehicle.
Covers removal, checking, and installation of the camshaft.
Details procedures for removing, checking, and installing the cylinder head.
Covers removal, checking, and installation of valves, springs, and related parts.
Details procedures for removing, checking, and installing the cylinder and piston.
Details removal, checking, and installation of the clutch assembly.
Details procedures for separating, disassembling, checking, and assembling the crankcase.
Covers removal, checking, and installation of the crankshaft and balancer shaft.
Details removal, checking, and installation of the transmission components.
Covers circuit diagram, troubleshooting, and checking ignition components.
To Next Page