EasyManuals Logo

Yamaha YZ250FX 2019 User Manual

Yamaha YZ250FX 2019
398 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #391 background imageLoading...
Page #391 background image
KICKSTARTER KIT (OPTIONAL PARTS)
10-14
EAM30446
INSTALLING THE KICKSTARTER LEVER
1. Install:
Oil seal “1”
(to the right crank case cover)
TIP
Apply the lithium-soap-based grease on the oil
seal lip.
Install the oil seal with its numbers facing the
outside.
2. Install:
Kickstarter lever “1”
Washer
Bolt (kickstarter lever)
TIP
Install so that there is a clearance “a” of 5 mm
(0.2 in) or more between the kickstarter lever
and the frame and that the kickstarter lever does
not contact the right crankcase cover when it is
pulled.
EAM30395
STARTING THE ENGINE
Starting with the kickstarter
When using the kickstarter to start the engine,
follow the procedures as described below.
1. Fold out the kickstarter lever, push it down
lightly with your foot until resistance is felt.
2. With the throttle fully closed, push the kick-
starter down lightly until the gears engage,
and then push it down smoothly but forceful-
ly.
WARNING
EWA20320
Do not open the throttle while kicking the
kickstarter lever. Otherwise, the kickstarter
lever may kick back.
TIP
If the engine fails to start, push the engine stop
switch and give the kickstarter 10 to 20 slow
kicks at full throttle in order to clear the engine of
the rich air-fuel mixture retained in it.
EAM30396
MAINTENANCE
Removing the kickstarter kit
1. Remove:
Kick shaft assembly “1”
TIP
Unhook the torsion spring “2” from the hole “a” in
the crankcase.
Bolt (kickstarter lever)
33 N·m (3.3 kgf·m, 24 lb·ft)
LOCTITE®
New
1
New
LS
T
R
.
.
1
a

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yamaha YZ250FX 2019 and is the answer not in the manual?

Yamaha YZ250FX 2019 Specifications

General IconGeneral
Displacement250cc
Bore x Stroke77.0mm x 53.6mm
Fuel SystemYamaha Fuel Injection (YFI), Keihin® 44mm
IgnitionTCI: Transistor Controlled Ignition
Final DriveChain
Front BrakeHydraulic disc, 270mm
Rear BrakeHydraulic disc, 245mm
Seat Height37.6 in
Ground Clearance12.8 in
Fuel Capacity2.1 gal
Wet Weight249 lb
Engine TypeLiquid-cooled DOHC 4-stroke
TransmissionWide-ratio 6-speed; multiplate wet clutch
Front SuspensionKYB® spring-type fork, fully adjustable
Rear SuspensionKYB® single shock
L x W x H32.5 in
Front Tire90/90-21
Rear Tire110/100-18

Related product manuals