3-23
GB
EMU00316
CRUISING IN OTHER
CONDITIONS
CRUISING IN SALT WATER
After operating in salt water, wash out the
cooling-water passages with fresh water
to prevent them from becoming clogged-
up with salt deposits.
NOTE:
Refer to cooling system flushing instruc-
tions in “TRANSPORTING AND STORING
OUTBOARD MOTOR”.
CRUISING IN TURBID WATER
It is strongly recommended that the
optional chromium-plated water-pump kit
be installed if the outboard is to be used
in turbid (muddy) water conditions.
EMU00303
PROCEDURE FOR TILTING DOWN
Power trim/tilt model
1) Push the power trim/tilt switch “UP”
until the engine is supported by the
tilt rod.
2) Release the tilt-support lever.
3) Push the power trim/tilt switch “DN”
(Down) to lower the engine to the
desired position.
68F-9-76A0-3b 2/20/03 5:45 PM Page 24
To Next Page
Loading...
Need help?
General
