Yamatake MagneW3000 PLUS User Manual

2 - 2
2.1 Before Installation
Selecting the Installation Site (1)
Introduction
In order to make full use of the device functions, please observe the following
criteria when selecting an installation site.
Notes :
• Install the product in a location with an ambient temperature of
-25°C - +60°C and an ambient humidity of 5 - 100% RH to prevent
equipment malfunction or output errors.
• Avoid installing the product near high-current power lines, motors,
or transformers to prevent damage from electromagnetic induction,
which may cause equipment malfunction or output errors.
• DO NOT use this product for grounding a welder, as it may cause
damage to the product.
• When welding near this product, be sure to ground the welding
power transformer.
• Avoid locations subject to severe vibration or highly corrosive
atmospheres to prevent detector breakage or equipment damage.
• Keep the product away from direct sunlight, wind, and rain to pre-
vent output errors.

Yamatake MagneW3000 PLUS Specifications

General

Repeatability	±0.1% of reading
Measurement Principle	Faraday's law of electromagnetic induction
Type	Magnetic Flowmeter
Fluid Temperature	-20°C to +180°C
Lining Material	PFA, PTFE
Electrode Material	Hastelloy
Accuracy	±0.5% of reading
Protection Degree	IP67
Output Signal	4 to 20 mA DC, Pulse, HART
Power Supply	24 V DC
Measurement Range	0 to 10 m/s
Operating Temperature	-20°C to +60°C