Yamatake MagneW3000 PLUS - Pre-Measurement Preparation; Zero Adjustment Importance and Methods

3 - 3
3.2 Preparations before Measurement
Zero Adjustment
Introduction
After start-up, be sure to zero the electromagnetic flowmeter. There are two
zero adjustment methods:
• Using the data setting device for this product
• Using the S-SFC (Refer to S-SFC User's Manual CM2-MGG000-2001
For electromagnetic flowmeters without the data setting device, select the
S-SFC method.
Both methods allow zeroing an electromagnetic flowmeter and employ a data
setting device.