ii Electronic Control System: Technical Manual for 6LY3 Series
NOTICE TO INSTALLER
The WARNINGS and CAUTIONS within this manual are used to alert the installer to hazards that exist
concerning a particular service, operation or component. They also may convey special instructions to
reduce the risk of injury during the operation or servicing of the engine.
However, these safety alerts alone cannot eliminate the hazards that they signal. Strict compliance to
these
special instructions when performing installation, operation, and maintenance is the most effective ac-
cident prevention measure along with exercising care and using common sense when performing such
American Boat & Yacht Council (http://www.abycinc.org )
RECREATIONAL CRAFT DIRECTIVE 94/25/EC
This product has been designed to be compliant with the above Directive.
Maximum performance, and compliance with the EMC Directive, can only be ensured
by correct installation. It is strongly recommended that the installation conforms with
the following standards:
APPLICABLE STANDARDS
a) ISO 8846 Small Craft-Electrical Devices
Protection against ignition of surrounding fl ammable gases.
b) ISO = International Standards Organization
SAFE BOATING STATEMENT
This device meets or exceeds the applicable ABYC, ISO, and USCG safe boating rules,
regulations, standards, and guidelines.
SAFE BOATING ON THE WEB
U.S. Coast Guard www.uscg.mil
U.S. Power Squadron www.usps.org
NMEA 2000® is a regiatered trademark of the National Marine Electronics Association.
The information contained in this manual is believed to be accurate at the time of going to print but no responsibility, direct or consequential, can
be accepted for damage resulting from the use of this information. The manufacturers reserve the right to make changes, without notice, to any of
its products.
To Next Page
Loading...
Need help?
General
