11 OPE_EF312T&352T_en.doc
TRANSPORTING
Raise all implements and place in their locked-transport
position.
Do not drive tractor on road with implements in motion.
Couple brake pedals together at road speeds.
(only for two brake pedals type)
Do not make sharp turns at road speeds.
Always dim headlights before meeting another vehicle.
Keep light adjusted so they will not blind another
vehicle.
Before going down a steep hill, shift to the lowest speed
to control tractor with a little braking. Do not coast
downhill.
Do not stop or start suddenly when going uphill or
downhill.
When loading (or unloading) tractor onto vehicle, use
care as follows:
1) Use adequate loading ramp on loading dock.
2) Use lowest reverse speed when driving up loading
ramp.
3) Set parking brake and wheel blocks firmly under
vehicle wheels.
4) Do not try to drive onto trailer from ditch bank.
Secure load with chain binders and be sure they are
tight.
If chain binders are not available, use rope, wire,
blocks, or winch cable. Check load after traveling a few
kilometers and every 100 km thereafter to make sure
ties are not coming loose. Also, check after rough road
bumps.
To Next Page
Loading...
