DAILY CHECKS
Before starting the Sail-Drive, make sure it
is in good operating condition. Make sure
you check the following items:
Visual Checks
1. Check for damaged or missing parts.
2. Check for loose, missing or damaged
fasteners.
3. Check oil level. See Filling With
Lubricating Oil - SD20, SD50 and
SD50-4T on page 19.
4. Open cooling water cock before
operation. Drain cooling water and
close cooling water cock after
operation. See Engine Cooling Water
on page 29
NOTICE: If any problem is noted during the
visual check, the necessary corrective
action should be taken before you operate
the engine.
BEFORE YOU OPERATE
SD Operation Manual 23
© 2009 Yanmar Marine International
To Next Page
Loading...
