21
STORAGE (30 DAYS OR LONGER)
● CLEANING - Thoroughly clean the tool exterior.
● INSPECTION - Inspect the entire tool for damage, including loose or
missing components and repair as necessary.
● FUEL - Drain the fuel tank and then clear the carburettor and lines
by running the tool until it stops from lack of fuel.
● LUBRICATION - Remove the spark plug and then pour
approximately a teaspoon of 2 stroke oil into the cylinder through the
spark plug hole. Before reinstalling the spark plug, pull the starter 2
or 3 times to distribute the oil over the cylinder walls.
● AIR FILTER - Remove, clean and reinstall the lter element.
● STORAGE - Store the tool in a clean, dry, dust-free environment.
STORAGE
At the end of the life of the product please recycle/dispose of the
product and any waste liquids in accordance to the regulations and
requirements of your local council.
To Next Page
Loading...