21
Checking the chain lubrication
As shown in Fig11
The product may not be used without adequate chain lubrication. Inadequate lubrication reduc-
es the service life of the product..
1. Check the oil quantity in the tank.
2. Switch on the device. (see the later section “switch on/off” )
3. Hold the running chain saw approx. 15cm above a suitable surface for a short time. If the
saw blade is adequately lubricated, the oil sprayed by the chain saw will leave a slight trail.
NOTE: If the saw blade is not adequately lubricated, please contact authority Service
center.
Fig 11
A suitable surface
Slight trail
ADJUSTMENT
To Next Page
Loading...
