Yard force LS G30A User Manual

25
Charging the battery pack
As shown in Fig15
NOTE! Remove the battery pack from the charger after it has been fully charged .
NOTE! This battery pack has been shipped in a low charge condition,it should be fully
charged before rst use.
NOTE! make sure the main voltage is the same as rating label which located on the
charger.
1. Connect the charger to a power supply. You will hear a beep sound .and the green LED
Light will be on .
2. To insert the battery pack into the charger, align the raised ribs of the battery pack with
the grooves of the charger, then push it in. Ensure the battery pack is in its place.
3. The charger will communicate with the battery pack’s circuitry to evaluate the capacity of
the battery pack. Charging status as following chart:
Fig 15
To charge the battery pack
R
G1
G2
G3
G4
R: Red light
G: Green light
R G1 G2 G3 G4
Q>95%
80%<Q<95%
30%<Q<80%
Q<30%
Q: battery pack, capacity
Flash ON OFF
OPERATION

Yard force LS G30A Specifications

General

Brand	Yard force
Model	LS G30A
Category	Chainsaw
Language	English