19
TROUBLESHOOTING
TROUBLESHOOTING
WARNING!
servicing the tool. Disconnect power supply before service.
Problem
Tool will not start.
Tool will not vacuum.
Tool will not blow.
Internal damage or wear.
Internal damage or wear.
Vacuum cover vacuum cover
blower coverBlower cover
No power at outlet.
Cord not connected.
Have authorized service
center service tool.
Have authorized service
center service tool.
Check power at outlet. If
Check whether the On/Off
switch is in the On position.
outlet is unpowered, turn
breaker. If breaker is tripped,
make sure circuit is right
capacity for tool and
circuit has no other loads.
Check that cord is plugged in.
Possible Cause
Tool's On/Off switch is in
the OFF position.
Fault Correction
NOTE: If the tool vibrates, please immediately stop using it. Have the tool inspected by an
authorized service center.
To Next Page
Loading...
