Yard force YF1801 - Page 18

To
stop the
engine
As
shown in Fig
15
Move
the throttle
lever
to the
stop
position.
Fig.
15
To
clean
a
flooded
engine
NOTE!
lf the
engine
won't
start
after
you
have
operated
the
starlerseveral
times,
the
engine may
be
flood
with
excess fuel
.
Use following
procedure
to
clear
and
start
a
flooded
engine.
1.
Move
the
throttle lever
to the
stop
position
to
stop
engine.
2. Remove
the
spark
plug,
dry it,
and then
reinstall
it.
NorEllnstallthe
spark
plug
carefully
by hand,
to
avoid
cross-threading.
After
the
plug
is
seated
tighten
1/8
to 1/4turn
with
socket
spanner
of spark
plug
to
compress
the
washer.
3.
Move the
throttle
lever
to
the rabbit
position
.
4.
Operate the
starter
as described
above.
Mowing
1.
Select
your
required
cutting
height.
2.
Start the
engine
and allow
it run.
See
"to
start the
engine,,
A
A
WARNING!
Always
observe
the
strictest
safety
procedures
when
using the
lawnmower.
Carefully
read
the
safety instructions
of this
manual
before
using
the
lawnmower.
WARNING!
Never
open the
ejector flap
when
the
grass
bag has
been
detached
(to
be
emptied)and
the
engine
is
still running.
The
rotating
blade
can
cause
serious
injuries!
17
YARtf
FC,REE
OPERATION