12
SETUP
2. Slip the vinyl clip bindings over the frame. (Fig. 7)
TO PREPARE BATTERY.
CAUTION: 1. Improper use of battery pack and charger can result in electric shock and re.
2. Keep battery charger and pack dry. Avoid exposing battery pack and charger to rain or wet
conditions.
3. To reduce the risk of electric shock, do not allow water to ow into AC plug.
4. Do not short circuit. Never place any object into the battery pack terminals.
NOTE:Your battery must be charged before you can start your lawn mower using the electric start.
CHARGING BATTERY PACK(Fig. 8)
NOTICE:
- The battery pack is supplied partially charged. To ensure the best performance, charge the battery
completely before rst use.
- Make sure the main voltage is the same as rating label which is located on the charger.
- Remove the battery pack from the charger after it has been fully charged.
1. Connect the charger to a power supply. The red LED light on the charger will illuminate.
2. To insert the battery pack into the charger, align the grooves on the battery pack with the raised ribs in
the opening of the charger.
3. Once the battery pack is correctly located in the charger, the green LED light of the charger will ash
continuously during normal charging.
4. When charging is complete, the green LED lights of the charger will illuminate.
This 20V Li-Ion battery pack is equipped with a power indicator which is used to show the battery pack’s
remaining charge. Press the power indicator button to check battery charge as shown above.
Fig. 8 Fig. 9
Fig. 7
To Next Page
Loading...
Need help?
General
