23
MAINTENANCE
IMPORTANT: Simply shutting OFF engine will not release pressure in the system. When the engine has
shut down, squeeze the trigger on the spray gun to relieve the pressure in the hose.
ENGINE MAINTENANCE
See the engine owner’s manual for instructions on how to properly maintain the engine.
CAUTION! Avoid prolonging or repeating skin contact with used motor oil. Used motor oil has been
shown to cause skin cancer in certain laboratory animals. Thoroughly wash exposed areas with soap
and water.
KEEP OUT OF REACH OF CHILDREN. DON'T POLLUTE. CONSERVE RESOURCES. RETURN
USED OIL TO COLLECTION CENTERS.
PREPARING THE UNIT FOR STORAGE
Water should not remain in the unit for long periods of time. Sediments or minerals can deposit on
pump parts and “freeze” pump action. If you do not plan to use the pressure washer for more than 30
days, follow this procedure:
1. Flush chemical injection hose by placing the lter into a pail of clean water while running pressure
washer in low pressure mode (adjustable nozzle in the forward position). Flush for one to two
minutes.
2. Shut off the engine and let it cool, then remove high pressure and garden hoses. Disconnect spark
plug wire from spark plug.
3. Empty the pump of all pumped liquids by pulling the recoil handle about 6 times. This should remove
most of the liquid in the pump.
4. Use Pump Saver to prevent corrosion build up and freezing of pump.
5. Store unit in a clean, dry area.
Protecting the Pump
To protect the pump from damage caused by mineral deposits or freezing, use Pump Saver to treat
pump. This prevents freeze damage and lubricates pistons and seals.
NOTE: Pump Saver is available as an optional accessory. It is not included with the pressure washer.
Contact the nearest authorized service center to purchase Pump Saver.
CAUTION! You must protect your unit from freezing temperatures. Failure to do so will permanently
damage your pump and render your unit inoperable. Freeze damage is not covered under warranty.
CAUTION! Read and follow all cautions and warnings on the PumpSaver can label. Always wear eye
protection when using PumpSaver.
To use PumpSaver, make sure the pressure washer is turned off and disconnected from supply water.
Read and follow all instructions and warnings given on the PumpSaver container.
NOTE: PumpSaver will drip from pump after treatment and will stain wood and concrete.
NOTE: If PumpSaver is not available, draw RV antifreeze (non-alcohol) into the pump by pouring the
solution into a 3-foot section of garden hose connected to inlet adapter and pulling recoil handle twice.
STORING THE ENGINE
See the engine owner’s manual for instructions on how to properly prepare the engine for storage.
To Next Page
Loading...
