8
and under seams.
Measurements to
3
4
1
Use a level and check that the frame is level before applying oor panels.
Check for frame squareness by measuring diagonally across corners. If the measurements are the
same, the frame is square. The diagonal measurement will be approximately .
When the frame is level and square, secure one side of frame to the 4x4 runners using one
fastener at ends of each runner .
At the opposite end of the frame, secure the frame to 4x4 runners using one fastener at ends of
each runner making sure the frame remains square .
Once the oor frame is level and square,
fasten the frame at each point the frame contacts the 4x4 runners .
See page 7 for the preferred oor leveling method.
FINISH
LEVEL AND SQUARE FLOOR FRAME
Before attaching oor decking, it is important to level and square the oor frame.
A level and square oor frame is required to correctly construct your shed.
(Floor frame and decking not included.)
•
•
the frame and where the
one fastener.
To Next Page
Loading...
Need help?
General
