Measure and mark location of hole on outside of right door as shown .
Pre-drill pilot hole using 1/4" dril.
Pre-drill through hole using 1/2" drill.
Keep drilled hole square
to trim to avoid breaking
edge of door stiffener.
You have nished installing your T-handle.
1
FINISH
4
3
Insert handle in hole and secure using 1-1/2" (3,8 cm) screws .
Attach inside handle and secure with set screw as shown.
TOP VIEW
1-3/4"
3,8 cm
82
SINGLE DOOR HARDWARE
PARTS REQUIRED:
1/2" (13 mm) Drill Bit
1/4" (6 mm) Drill Bit
1-3/4"
(4,4 cm)
Shaft
Set Screw
35-3/4"
(90 cm)
To Next Page
Loading...
