To do so:
1. Loose the two nuts which secure the chute bracket
and reposition it slightly.
2. Retighten the nuts.
Figure 15
Drift cutters break up snow drifts that are taller
than the auger housing and direct the snow into
the auger. Store the drift cutters on the auger
housing when not in use. Reposition drift cutters
so they face forward as shown. Wing nuts should
be fastened on the outside of the auger housing.
DRIFT CUTTERS (OPTIONAL)
Figure 16a
Figure 16b
PLASTIC SKID SHOES (OPTIONAL)
Optional reversible poly skid shoes protect
decorative surface.
Figure 14
10
mm
X 2
16
Two-Stage Snow Blower
»
Operator’s Manual
Adjustment
|
To Next Page
Loading...
