Refer to the Engine Operator’s Manual.
AUGER GEARBOX
7KH JHDUER[ZDV ĆOOHG ZLWKOXEULFDQW WR WKH SURSHU OHYHO DW WKH
factory. Unless there is evidence of leakage or service has been
performed on the gearbox, no additional lubricant should be
required. If lubricant is required, use GL-5 or GL-6, SAE85-95, EP
gear oil lubricant. Do not use synthetic oil.
MAINTENANCE
ENGINE
GENERAL LUBRICATION
Lightly lubricate all moving parts of the machine at the end of the
season or every 25 operating hours.
Oil
Grease
Do not allow grease or oil get on friction disc, friction
plate or belts. Do not excessively oil the machine; extra
oil may enter the traction drive and cause the traction
drive belt to slip.
When lubricating auger shaft, remove shear pins
to apply oil inside the shaft and around spacers and
ćDQJHEHDULQJVIRXQGDWHLWKHUHQGRIWKHVKDIW
Remove the wheels to apply grease the wheel shaft.
19
|
Maintenance
To Next Page
Loading...
Need help?
General
