model number 054-5764-4 | contact us: 1.866.523.5218
24
Keep a running saw clear or wire fencing or the ground.
Use of the saw to thin out branches or bushes is not approved.
Length cuts must be carried out with care, as leverage with the spiked bumper (9) is not
QPTTJCMF4BXBUB«BUBOHMFUPBWPJELJDLCBDL
When working on a slope, operate above or to the side of the trunk or laying tree.
Be careful not to trip over tree stumps, branches, roots, etc.
8. CUTTING WOOD UNDER TENSION (See Fig. N)
There is a high risk of accidents when sawing wood, branch or trees under tension. Be
extremely careful.
-FBWFTBXKPCTMJLFUIFTFUPQSPGFTTJPOBMT
When sawing logs supported on both ends, start the cut from above (Y) about 1/3 of the
EJBNFUFSJOUPUIFMPHBOEUIFOªOJTIUIFDVU;GSPNCFMPXJOPSEFSUPBWPJEDPOUBDUPGUIF
chainsaw with the ground. When sawing logs supported on only one end, start the cut from
CFMPX:BCPVUPGUIFEJBNFUFSJOUPUIFMPHBOEªOJTIUIFDVUGSPNBCPWF;JOPSEFSUP
BWPJEMPHTQMJUUJOHPSKBNNJOHPGUIFDIBJOTBX
9. FELLING TREES (See Fig. O)
Always wear hard hat to protect head against falling branches.
The chainsaw can only be used to fell trees smaller in diameter than the length of the
guide bar.
1. Secure work area. Ensure no persons or animals are in the vicinity of the falling tree.
/FWFSBUUFNQUUPGSFFBKBNNFETBXXJUIUIFNPUPSSVOOJOH6TFXPPEFOXFEHFTUPGSFF
chain and guide bar.
When cutting and felling operations are being performed by two or more persons at the
same time, the felling operations should be separated from the cutting operation by a
distance of at least twice the height of the tree being felled. Trees should not be felled in
a manner that would endanger any person, strike any utility line or cause any property
EBNBHF*GUIFUSFFEPFTNBLFDPOUBDUXJUIBOZVUJMJUZMJOFUIFDPNQBOZTIPVMECFOPUJªFE
Assembly
Z
Y
kg
Z
Y
N
To Next Page
Loading...
Need help?
General
