STARTING AND STOPPING THE MOWER (Fig. 5)
11
OPERATING YOUR LAWN MOWER
Starting the mower:
• Plug the mower into an approved outdoor extension cord.
• Press and hold the Power button (1). This makes the Bail switch operational.
• Pull the bail switch (2) upward to the handlebar to operate and release the Power button.
Stopping the mower:
• Release the Bail switch.
CIRCUIT BREAKER (Fig. 5)
This mower is equipped with a circuit breaker in order to protect the supply circuit from short-circuit
overloads.
Follow these steps if the switch pops out:
1. Release the bail switch, and allow the mower to stop and cool down for a minute.
2. Press down the circuit breaker in order to reset it. Resume operation.
Follow these steps if the switch pops out again shortly after the first time:
1. Allow the mower to stop and cool down for 15 to 30 minutes.
2. After the mower has cooled down, press down the circuit breaker in order to reset it. Resume
operation.
If the circuit breaker does not stay in, or if it continues to pop out during operation, contact the
Toll-Free Helpline, at 1-866-523-5218.
1
2
3
Bail switch
Power
button
Circuit
breaker
Plug
connector
Fig. 5
To Next Page
Loading...
Need help?
General
