Yardworks 31AM63KE515

Questions and Answers

P
Patrick SmithAug 6, 2025
How to start my Yardworks 31AM63KE515 if the engine fails to start?
- D
  Debbie LangAug 6, 2025
  If your Yardworks Snow Blower engine won't start, several factors could be the cause. First, ensure the choke is in the CHOKE position. Next, check that the spark plug wire is securely connected to the spark plug. Also, verify that the fuel tank isn't empty or filled with stale fuel; if so, replenish it with clean, fresh gasoline. Additionally, ensure the engine is properly primed as instructed. Inspect the spark plug for any faults and clean, adjust the gap, or replace it if necessary. Finally, make sure the key is fully inserted into the ignition switch.
R
Roger PerkinsAug 13, 2025
What to do if my Yardworks Snow Blower won't discharge snow?
- M
  Manuel HarperAug 13, 2025
  If your Yardworks Snow Blower isn't discharging snow, immediately stop the engine and disconnect the spark plug wire. Check for a clogged chute assembly and clean it, along with the inside of the auger housing, using a clean-out tool or stick. Also, inspect the auger for any foreign objects and remove them with a clean-out tool or stick. Finally, check the shear pins and replace with new ones if sheared.
K
kimberly03Aug 19, 2025
Why is my Yardworks 31AM63KE515 engine running erratically?
- J
  Jessica SanchezAug 19, 2025
  If your Yardworks Snow Blower engine is running erratically, with inconsistent RPMs, several factors could be the cause. Ensure the engine isn't running on CHOKE by moving the choke lever to the RUN position. Stale fuel can also cause this issue, so fill the tank with clean, fresh gasoline. Additionally, check for water or dirt in the fuel system; if present, drain the fuel tank and refill with fresh fuel.
M
Michael CollinsAug 25, 2025
Why is my Yardworks 31AM63KE515 losing power?
- S
  Susan JohnsonAug 26, 2025
  If your Yardworks Snow Blower is losing power, check the spark plug wire to ensure it is connected and tightened. Also, examine the gas cap vent hole for any blockage from ice or snow, and clear it to ensure proper ventilation.
K
knightscottAug 30, 2025
What causes excessive vibration in my Yardworks 31AM63KE515 Snow Blower?
- D
  deanna19Aug 30, 2025
  If your Yardworks Snow Blower is vibrating excessively, stop the engine immediately and disconnect the spark plug wire. Tighten all bolts and nuts. If the vibration continues, have the unit serviced by an authorized Service Center.

Summary

To The Owner

Record Product Information

Record model and serial number for technical support and warranty.

Customer Support

Contact customer support for assembly, operation, or maintenance assistance.

Important Safe Operation Practices

Training

Learn how to safely operate the machine, including understanding controls and safety procedures.

Preparation

Prepare the operating area and yourself by removing hazards and wearing proper gear.

Safe Handling of Gasoline

Operation

Clearing a Clogged Discharge Chute

Maintenance & Storage

Safety Symbols

Assembly & Set-Up

Handle Assembly

Step-by-step guide to assembling the snow thrower's handles.

Chute Assembly

Instructions for attaching the chute assembly to the snow thrower base.

Drift Cutters (If Equipped)

Instructions for installing or repositioning drift cutters for heavy snow.

Clean-Out Tool

Location and purpose of the chute clean-out tool.

Lamp Wiring Harness (If equipped)

Instructions for connecting the lamp wiring harness.

Shear Pin Storage (optional)

Location of optional shear pin storage.

Tire Pressure

How to check and adjust tire pressure for safe operation.

Adjustment

Chute Assembly

How to adjust the chute angle to control snow throw distance.

Chute Bracket Adjustment

How to adjust the chute bracket for proper engagement.

Skid Shoes

How to adjust skid shoes for different terrain conditions.

Auger Control Test

Controls and Features

Shift Lever

Explanation of the shift lever for speed and direction control.

Skid Shoes

How to position skid shoes based on surface conditions.

Augers

How augers function to draw in snow.

Chute Assembly

How snow is discharged through the chute.

Headlight (if so equipped)

Operation of the headlight.

Drift Cutters (if so equipped)

Use of drift cutters for deep snow.

Auger Control

How to engage and disengage the augers for snow throwing.

Chute Clean-Out Tool

Safe procedure to clear a clogged chute using the clean-out tool.

Two-Way Chute Control (optional)

How to control snow discharge distance with the two-way chute control.

Chute Directional Control (optional)

How to change the direction of snow discharge.

Operation

Starting and Stopping the Engine

Reference to engine manual for starting and stopping procedures.

To Engage Drive

How to engage the drive system to move the snow thrower.

To Engage Augers

How to engage augers to start throwing snow.

Replacing Shear Pins

Procedure for replacing shear pins that protect the auger.

Maintenance & Adjustments

Engine

Refer to engine manual for engine maintenance.

Tire Pressure

Refer to Assembly & Set-Up for tire pressure checks.

Shave Plate and Skid Shoes

Inspecting and replacing shave plates and skid shoes due to wear.

Lubrication

Lubrication points for gear shaft and auger shaft.

Chute Assembly

Skid Shoes

Drive Control

Shift Cable

Auger Control

Off-Season Storage

Service

Belt Replacement

Step-by-step guide for replacing the auger belt.

Drive Belt

Friction Wheel Removal (600 Series)

Friction Wheel Inspection (500 Series)

Friction Wheel Replacement (Rubber Ring)

Troubleshooting

Engine fails to start

Lists causes and remedies for engine starting issues.

Engine running erratically;inconsistent RPM

Lists causes and remedies for engine performance issues.

Engine overheats

Lists causes and remedies for engine overheating.

Excessive vibration

Lists causes and remedies for excessive machine vibration.

Loss of power

Lists causes and remedies for loss of engine power.

Unit fails to propel itself

Lists causes and remedies for the unit not moving.

Unit fails to discharge snow

Lists causes and remedies for snow not being discharged.

Chute fails to easily rotate 180 degrees

Lists causes and remedies for chute rotation issues.

Replacement Parts

4 YEAR LIMITED WARRANTY

How to Obtain Service

Instructions on how to get warranty service and support.

FEDERAL and;or CALIFORNIA EMISSION CONTROL WARRANTY STATEMENT

MANUFACTURERS WARRANTY COVERAGE

Coverage period for emission control system warranty.

OWNERS WARRANTY RESPONSIBILITIES

Owner's responsibilities regarding maintenance and warranty claims.