Chute Rod Adjustment
If the chute fails to remain stationary during operation, increase
the preload on the chute control rod.
While preventing the chute control rod from turning •
tighten the nut on the chute gearbox assembly. See Fig.
6-7.
If the chute directional control is difficult to crank, decrease the
preload by loosening the hex nut counterclockwise in ¼ turn
intervals.
Off-Season Storage
If the snow thrower will not be used for 30 days or longer, follow
the storage instructions below.
Lubricate the machine as instructed earlier in this section.1.
Store in a clean, dry area.2.
If storing the snow thrower in an unventilated area, 3.
rustproof the machine using a light oil or silicone to coat
the snow thrower.
Clean the exterior of the engine and the snow thrower.4.
NOTE: Refer to the Engine Operator’s Manual for information on
storing your engine.
Fig. 6-7
18 SectioN 6 — MaiNteNaNce & adjuStMeNtS
To Next Page
Loading...
Need help?
General
