Yardworks 760-779 User Manual (English)

Questions and Answers:

R
Rick BrownAug 13, 2025
Why Yardworks 760-779 engine fails to start?
- L
  Leonard WelchAug 13, 2025
  Your Yardworks Lawn Mower engine might fail to start due to several reasons: the PTO might be engaged (disengage it), spark plug wires might be disconnected (connect them), the fuel tank might be empty or contain stale fuel (fill it with fresh gasoline), the choke might not be activated (activate it), the spark plug might be faulty (clean, adjust, or replace it), the fuel line might be blocked (clean it or replace the fuel filter), the engine might be flooded (crank it with the throttle in the FAST position), the parking brake might not be engaged (engage it), or the throttle control lever might not be in the correct starting position (place it in the FAST position).
A
Austin MendezAug 20, 2025
Why Yardworks 760-779 engine overheats?
- S
  Samuel ShieldsAug 20, 2025
  Your Yardworks Lawn Mower engine might overheat if the engine oil level is low (fill the crankcase with the proper oil) or if the airflow is restricted (clean grass clippings and debris from around the engine’s cooling fins and blower housing).
P
Phillip HillAug 25, 2025
How to fix uneven cut with Yardworks 760-779?
- V
  vramosAug 25, 2025
  An uneven cut with your Yardworks Lawn Mower can be caused by a deck that is not balanced properly (perform a side-to-side deck adjustment), a dull blade (sharpen or replace the blade), or uneven tire pressure (check the tire pressure in all four tires).
M
Mary BrooksAug 27, 2025
What to do if Yardworks 760-779 idles poorly?
- J
  Jennifer Good DDSAug 27, 2025
  If your Yardworks Lawn Mower idles poorly, the spark plugs might be fouled, faulty, or have a gap that is too wide (replace the spark plugs and set the gap). Another potential cause is a dirty air cleaner (replace the air cleaner cartridge/element or clean the pre-cleaner, if equipped).
L
Lisa BrooksSep 1, 2025
What to do if Yardworks Lawn Mower will not mulch grass?
- S
  Sandra JohnstonSep 1, 2025
  If your Yardworks Lawn Mower isn't mulching grass, it could be due to a few reasons: the engine speed might be too low (place the throttle control in the FAST position), the grass might be wet (wait until it's dry), the grass might be excessively high (mow at a high cutting height first, then again at the desired height, or make a narrower cutting path), or the blade might be dull (sharpen or replace it).
E
Eric MarshallSep 4, 2025
What causes excessive vibration in Yardworks 760-779?
- C
  Carlos JonesSep 4, 2025
  Excessive vibration in your Yardworks Lawn Mower can be attributed to a cutting blade that is either loose or unbalanced (tighten the blade and spindle and balance the blade), or a cutting blade that is damaged or bent (replace the blade).
Z
zkellySep 8, 2025
Why Yardworks Lawn Mower engine hesitates at high RPM?
- B
  brittanyshermanSep 8, 2025
  If your Yardworks Lawn Mower engine hesitates at high RPM, it could be because the spark plug gap is too close. Remove the spark plug and reset the gap.

Yardworks 760-779 Specifications

General

Power Source	Electric
Voltage	120 V
Blade Material	Steel
Collection System	Rear Bag
Wheel Size	7 inches

Summary

Finding and Recording the Model Number

Customer Support

Slope Gauge

Safe Operation Practices

Children

Safety instructions regarding children's presence and interaction with the machine.

Operation

Guidelines for safe gasoline handling, including refueling and storage to prevent hazards.

General Operation

Essential operating rules, safety gear, and clothing recommendations for safe use.

Slope Operation

Safe operating procedures for slopes, including turning, speed, and avoiding hazards.

Towing

Safety advice for towing attachments, covering weight limits and proper towing techniques.

Service

Maintenance safety checks, including blade stoppage, brake operation, and general safety.

Setting Up Your Lawn Tractor

Attaching the Battery Cables

Step-by-step guide for connecting battery cables, ensuring proper polarity and protection.

Gas and Oil Fill-up

Instructions and safety warnings for filling fuel and oil tanks correctly.

Shipping Brace Removal

Procedures for safely removing shipping braces before operating the tractor.

Attaching The Steering Wheel

Guide to installing the steering wheel, including hardware and cap.

Attaching The Seat

Instructions for attaching and adjusting the tractor seat for operator comfort.

Identifying the Mulch Plug (if so equipped)

How to locate and remove the mulch plug for grass discharge.

Tire Pressure

Critical information on maintaining correct tire pressure for safe operation.

Operating Your Lawn Tractor

Know Your Lawn Tractor

Overview of the tractor's controls and components with a diagram.

Throttle Control Lever

How to use the throttle lever for engine speed and choke.

Ignition Switch

Steps for starting and stopping the engine using the ignition switch.

PTO (Blade Engage) Lever

How to engage and disengage the PTO lever for attachments.

Safety Interlock Switches

Explanation of safety interlocks preventing unsafe operation.

Reverse Caution Mode (If Equipped)

Safe use of reverse caution mode with critical warnings for reverse operation.

Starting the Engine

Detailed procedures for safely starting the tractor's engine.

Driving On Slopes

Safety rules for operating on slopes to prevent tip-overs.

Mowing

Tips for effective mowing, including speed, direction, and height.

Mulching (If Equipped)

Best practices for mulching grass, covering conditions and techniques.

Adjusting Your Lawn Tractor

Leveling the Deck

Procedures for adjusting the cutting deck for even mowing.

Parking Brake Adjustment

How to adjust the parking brake for proper function.

Seat Adjustment

Instructions for adjusting the tractor seat for operator comfort.

Maintaining Your Lawn Tractor

Engine

Reference to engine maintenance and checking oil levels.

Changing Engine Oil and Filter

Steps for changing engine oil and servicing the oil filter.

Lubrication

Guide to lubricating key tractor components.

Cutting Deck Removal

Step-by-step instructions for safely removing the cutting deck.

Tires

Critical information on tire pressure for safe operation.

Battery

Battery maintenance, terminal cleaning, and safe handling.

Cutting Blades

Guide on safely removing, sharpening, and replacing cutting blades.

Changing the Deck Belt

Steps for safely replacing the cutting deck belt.

Off-Season Storage/Attachments

Attachments & Accessories

List of compatible attachments and accessories for the tractor.

Safety Labels

Trouble Shooting

Warranty

Replacement Parts

Related product manuals