17
4
Operating
Your Lawn
Tractor
WARNING
Driving The Tractor
WARNING: Avoid sudden starts,
ex-cessive speed and sudden
stops.
WARNING: Do not leave the seat
of the tractor without first placing
the PTO (Blade Engage) lever in
the disengaged (OFF) position,
depressing the brake pedal and
engaging the parking brake. If
leaving the tractor unattended,
also turn the ignition key off and
remove the key.
WARNING: Always look down
and behind before and while
backing up to avoid a back-over
accident.
1. Depress the brake pedal to release the parking brake
and let the pedal up.
2. Move the throttle lever into the FAST (rabbit) position.
3. Place the shift lever in either the FORWARD or
REVERSE position.
IMPORTANT: Do NOT use the shift lever to change the
direction of travel when the tractor is in motion. Always
use the brake pedal to bring the tractor to a complete
stop before shifting.
4. Release the parking brake by depressing the clutch-
brake pedal and positioning the speed control lever in
desired position.
IMPORTANT: First-time operators should use speed
positions 1 or 2. Become completely familiar with the
tractor’s operation and controls before operating the
tractor in higher speed positions.
5. Release clutch-brake pedal slowly to put unit into
motion.
6. The lawn tractor is brought to a stop by depressing
the clutch-brake pedal.
NOTE: When operating the unit initially, there will be little
difference between the highest two speeds until after the
belts have seated themselves into the pulleys during the
break-in period.
WARNING: Before leaving the
operator’s position for any rea-
son, disengage the blades, place
the shift lever in neutral, engage
the parking brake, shut engine off
and remove the key.
IMPORTANT: When stopping the tractor for any reason
while on a grass surface, always:
1. Place the shift lever in neutral,
2. Engage the parking brake,
3. Shut engine off and remove the key.
Doing so will minimize the possibility of having your lawn
‘‘browned’’ by hot exhaust from your tractor’s running
engine.
If unit stalls with speed control in high speed, or if unit
will not operate with speed control lever in a low speed
position, proceed as follows:
1. Place shift lever in NEUTRAL.
2. Restart engine.
3. Place speed control lever in highest speed position.
4. Release clutch-brake pedal fully.
5. Depress clutch-brake pedal.
6. Place speed control lever in desired position.
7. Place shift lever in either FORWARD or REVERSE,
and follow normal operating procedures.
Do not mow on in-
clines with a slope in
excess of 15 degrees
(a rise of approxi-
mately 2-1/2 feet every
10 feet). The tractor
could overturn and
cause serious injury.
Always look down
and behind before
and while backing up
to avoid a back-over
accident.
To Next Page