Serial Communication Option Ki
for GPD 315/V7
Yaskawa Electric America Inc-www.drives.com
02Y00025-0514 Page 2 of 8
Date: 08/23/01
INSTALLATION:
Note: Figure 1 Intentionally deleted.
1) Remove top screw from faceplate
2) Remove the faceplate from the drive
and remove bottom screw (highlighted
by bottom circle in Figure 2).
Figure 2
3) After the screw is removed, the NEMA1
Endcap Bracket can be pulled off. The
black circles (Figure 3) shows where the
ground screws are located. This will be
the point of connection for the ground wire
from the serial communication kit.
Figure 3
To Next Page
Loading...