Serial Communication Option Ki
for GPD 315/V7
Yaskawa Electric America Inc-www.drives.com
02Y00025-0514 Page 6 of 8
Date: 08/23/01
10) Remove the pan-head screw (brass-
colored) and the metal connection plate
from the plastic bag containing hardware.
There are two holes in the connection
plate: One is for the pan-head screw, and
one is for the plastic mounting hub. Place
the metal connection plate on the in the
manner shown in figure 10, and tighten
with Philips screwdriver.
Figure 10
11). If necessary, tuck the blue wire into
the enclosure of the GPD315/V7 drive and
position the Serial Communication Kit on
top of the drive in the manner shown in
Figure 11. MAKE SURE THAT BLUE
WIRE IS NOT GETTING PINCHED
BETWEEN THE SERIAL
COMMUNICATION KIT AND THE DRIVE
OR ELSEWHERE!!
Figure 11
To Next Page
Loading...