YASKAWA MOTOWELD-T300D - Page 40

40
(Rear side)
(Front side)
F2: Fuse 10 A
F3: Fuse 8 A
(For motor circuit)
OUT
IN
Magnetic
valve selector
switch
(Short)
(Long)
Wire feeder
selector switch
The following diagrams show the selector switches on the printed board.
Replace the shortcircuit cap as described below.
Note: To operate the adjusting volumes or selector
switches on the printed board, be sure to turn OFF
the power supply switch.
How to Operate Jumper Pin Type Selector Switch
in Board
Illustra-
tion
How to
Change