Inverter SIO Driver
GP-Pro EX Device/PLC Connection Manual
18
î External Device Settings
To configure communication settings, use the DSPL, DATA/ENTER, Up, or Down key on the digital operator
located on the front of the inverter. Refer to your External Device manual for details.
1 Press the DSPL key to select [PRGM].
2 Press the Up key to display the parameter you want to set.
3 Press the DATA/ENTER key.
4 Press the Up or Down key to display the setting value.
5 Press the DATA/ENTER key.
6 Reboot the External Device.
This completes the setting of the External Device.
Parameter No. Settings Setup Description
n02 2 RUN Command Selection
n03 6 Frequency Reference Selection
n70 1 Slave Address Setting (DEC)
n71 2 Baud Rate Selection
n72 0 Parity Selection
n73 10 Transmission Wait Time
n74 0 RTS Control
To Next Page
Loading...
Need help?
General