YASKAWA Varispeed f7

Inverter SIO Driver
GP-Pro EX Device/PLC Connection Manual
2
Introduction
This manual describes how to connect the Display and the External Device (target inverter).
In this manual, the connection procedure is described in the sections identified below.
1
System Configuration
This section lists the types of External
Devices and SIO that you can connect.
)"1 System Configuration" (page 3)
2
External Device Selection
Select a model (series) of the External
Device and its connection method.
)"2 External Devices Selection" (page 8)
3
Communication Settings
This section shows setting examples for
communicating between the Display and
the External Device.
)"3 Communication Settings" (page 9)
4
Setup Items
This section describes communication
setup items on the Display. Set the
Display’s communication settings in GP
Pro-EX or in off-line mode.
)"4 Setup Items" (page 45)
5
Cable Diagrams
This section shows cables and adapters
for connecting the Display and the
External Device.
)"5 Cable Diagrams" (page 49)
Operation