OPERATIONS
The compressor will start to work after the fan works for a few seconds.
The compressor will shut down at once and the fan will stop after a few
seconds (when other malfunctions occur or humidity reaches the desired
level, the fan will stop after ten seconds).
Tips: The compressor features "3 minutes delay protection" function
While the dehumidifier is powered, the compressor can only start again
three minutes after its last shutdown.
Action Description
If the malfunctions still exist, please don't hesitate to contact Yuafey
Customer Service at for help.support@yaufey.com
Problems
Solutions
Does the humidity sensor fail?
Is there some water on the
surface of the humidity sensor?
Set the humidity to 30% RH and check
if the dehumidifier can work normally.
If it does, the machine is in a good
condition.
Repair or replace the humidity sensor.
The dehumidifier can work normally.
The moisture removal effect is not
affected.
Please keep the machine working for
a while to remove the water on the
humidity sensor surface. The machine
will work normally when the water is
removed.
Repair or replace the humidity sensor.
Humidity always shows
"25% RH" but there is a
big difference from the
actual humidity.
Humidity always shows
"99% RH" but there is a
big difference from the
actual humidity.
Notice:
Before turning on the machine, please be sure to have opened the air
outlet. Otherwise, the machine will overheat. Do not unplug the power
cord directly to turn off the machine.
Fault & Protection Codes:
To Next Page
