OPERATIONS
REMOVING THE COLLECTED WATER
NOTE:
Put the empty bucket back into the unit and once seated correctly, the unit
will start up again.
You should hear a click when the bucket is in the correct position. Do not
remove the float in the bucket, otherwise the sensor will not be able to
sense the water level properly, resulting in that the water will overflow
from the bucket when the bucket is full.
Caution: Please place the water tank in the right position. Otherwise, it
may cause full tank alert.
1. Take out the wanter bucket.
1. Use the bucket
2. Empty the water bucket.
3. Put the water bucket back to its proper position.
To Next Page
