Yealink SIP-T33

9. Basic call features
9.1 Making calls
You can switch call mode during a call by
pressing the
headset or speakerphone
key or by picking up the handset.
9.2 Answering calls
You can reject an incoming call by
pressing the reject soft key.
9.3 Ending calls
9.4 Redialling calls
There are three ways to make a call:
Pick up the handset, dial the number and press the green Call key or the #Send
With the handset on the hook, press the speakerphone key , dial the number
and press #Send.
With a headset connected, press the headset key , dial the number press Call or #Send .
You can answer a call in three ways:
Pick up the handset.
Press the Answer key or speakerphone
key.
Press the headset key with your headset connected.
To end a call:
Put the handset down or press End Call.
Press speakerphone or End Call
Press End Call with your headset connected.
To redial a number, press redial to get to the placed calls list. Then press up or
down
to find and select the number you want to redial . Then press redial again
or the Call key or
#
send .
Again you can scroll left and right for the different call types
9.5 Mute
9.6 Call hold and resume
Press mute key during a call so you can hear the other party but they can’t hear
you. Press it again to unmute.
Press Trans during a call to put it on hold. To go back on the call, press Resume . You will hear
dial tone for a few seconds (in case you do want to Transfer the call) then the
Resume key will
appear or if you press
Cancel the Resume key will appear instantly. Once the Resume key has
appeared if you press Cancel you will disconnect the caller.