6
Register status icons on the touch screen:
(Green) Registered
(Gray) Register Failed
(Green and Flashing) Registering
Note: Check with your system administrator if any error appears during the registration process or a specic conguration is required
for your registration.
Configuring via phone user interface
Network Settings:
1. Swipe down from the top of the screen to enter the control center.
2. Tap Settings->Advanced (default password: admin)->Network->WAN Port/VLAN /Webserver Type/802.1x/VPN/LLDP/CDP/NAT
to congure the network.
Account Settings:
1. Swipe down from the top of the screen to enter the control center.
2. Tap Settings->Advanced (default password: admin)->Accounts to congure the account.
Using Your Phone
Status Icons
The icons on the status bar of the touch screen give information about phone:
Icons
Description
(White)
(Green)
(White)
(Green)
(Green)
Shows that camera is not detected.
Shows that Wi-Fi is turned on.
Shows that the phone is connected to wireless network successfully.
Shows that wired network is unavailable.
Shows that Bluetooth is turned on.
Shows that Bluetooth headset is paired successfully.
Shows that Bluetooth-Enabled mobile phone is paired successfully.
Shows that the phone is locked.
Shows that "Forward" is turned on.
Shows that "Do Not Disturb" is turned on.
Shows that "Auto Answer" is turned on.
Shows that you have missed calls.
Shows that you have unread voice mails.
Shows that "Silent" is turned on.
Shows that a USB ash drive is detected.
E
N
G
L
I
S
H
To Next Page
Loading...
Need help?
General
