yellow jacket 60648 - Track Mode Operation; Peak Mode Operation

TRACK MODE OPERATION
TRACK MODE OPERATION
Buzzer
(((((((( )))))))) ((((((( )))))))
Apply Torque
Current Torque Value
Current Torque Value
*Note 1
START
(System initial)
((…((… …))…)) ((…((… …)) …))
Buzzer
Red LED
Approached Target Torque
Setting Target Torque
Green LED
Reach 80% of Target Torque
Reach Target Torque
Reach 80% of Target Torque
*Note 3
*Note 2
Note:
1. If is displayed, that means the wrench has applied
more than 110% of the specified torque.
2. When 80% of the target torque is reached, the green LED will
begin to flash and the alarm tone will beep intermittently.
3. When the target torque is approached, the alarm will change to
a steady tone and the green LED will stop flashing and stay on.
The red LED will also illuminate.
PEAK MODE OPERATION
[Type here]
PEAK HOLD MODE OPERATION
Red LED
Approached Target Torque
Buzzer
(((((((( )))))))) ((((((( )))))))
Reach Target Torque
Current Torq u e Value
(Peak Hold)
START
Apply Torque
((…((… …))…)) ((…((… …)) …))
Buzzer
Green LED
Reach 80% of Target Torque
Flashing
Apply Torque
Released
Setting Target Torque
Reach 80% of Target Torque
Recording
*Note 2
*Note 1
(System initial)
*Note 3
*Note 4
Note:
1. If is displayed, that means the wrench has applied
more than 110% of the specified torque.
2. If is displayed, that means the wrench’s memory
is full and the next value record cannot be stored. Please refer
to the “Peak Hold Mode Recorded Value Review” section to
clear the memory records.
3. When 80% of the target torque is reached, the green LED
will begin to flash and the alarm tone will beep intermittently.
4. When the target torque is approached, the alarm will change to
a steady tone and the green LED will stop flashing and stay
on. The red LED will also illuminate.
7
All manuals and user guides at all-guides.com