3-2. Reset Button And Low Battery Indicator
12
(0)
3-3. Lens Delay Control
1
Page 05
[13 The auto-darkening lens turns
on (darkens) automatically
when welding begins and turns
off 15 - 20 minutes after welding
stops.
I Reset Button
Press Reset button to check if the
lens is working properly.
When the Reset button is pressed,
the lens should darken and re-
to the clear state. Do not use the
helmet if the lens does not function
as described. (See Section 9, Trou-
bleshooting.)
2 Low Battery Indicator
The low battery indicator lights when
2-3 days of battery life remain.
If battery power is low, replace with
CR2450 lithium batteries (I
quired).
I Lens Delay Control
The lens delay control is used to
adjust the time for the lens to switch
to the clear state after welding.
The delay is particularly useful in
eliminating bright after-rays pres-
ent in higher amperage applica-
tions where the molten puddle re-
mains bright momentarily after
welding. Lens delay adjusts from
min (0.10 second) to max (0.8 sec-
ond.).
To Next Page
Loading...
Need help?
General
