Yeti SB150 User Manual

12. 13.
,&&1:063:&5*'3&4)
"/%$-&"/
OVERVIEW
Following these guidelines will help maintain the performance of your bicycle and
prevent more serious problems from arising. It is important to remember that
service intervals can vary depending on climate, trail conditions and riding
frequency. If you are unsure about working on your own bicycle, contact your
authorized Yeti Dealer for more information on general bicycle maintenance.
TORQ
UE
Y
eti strongly recommends using a torque wrench when assembling your frame. Torque
specifications for individual parts on the SB
150
are listed below, as well as in the step by
step assembly instructions later in the manual. For general bicycle maintenance please
consult the torque specifications of the component you are adjusting.
K
E
Y
TO
RQ
U
E
SP
ECS
PART NUMBER DESCRIPTION TORQUE (NM)
300040485 MAIN PIVOT AXLE 3.5
20002032 SS PIVOT BOLT, FEMALE 15
300030296 COLLET AXLE 30.5X10.5 M10X1.0 12
300040486
COLLET WEDE BOLT, LARE 14
300030293 LIN, PIVOT HARDWARE, MALE, 15MM 8
30006003 12X148 DERAILLER HANER 9
WEEKLY
MONTHLY
3 MONTHS
ANNUALLY
CLEAN AND LUBE CHAIN
CHECK TIRE PRESSURE
CLEAN BIKE OF MUD AND DEBRIS
CHECK BRAKE FUNCTION
CHECK SHOCK PRESSURE, IF APPLICABLE
CHECK FOR LOOSE BOLTS AND TIGHTEN, IF NECESSARY
CHECK HEADSET AND TIGHTEN / LOOSEN, IF NECESSARY
THOROUGHLY CLEAN PIVOT POINTS WITH A RAG (DO NOT LUBRICATE)
LUBE INFINITY LINK EVERY 40 HRS. (YETI HEAVY MOLYBDENUM GREASE)
CHECK / REPLACE BRAKE PADS, IF NECESSARY
CHECK TIRES FOR WEAR
CHECK SPOKE TENSION AND RETENTION, IF NECESSARY
CHECK CHAIN FOR WEAR AND REPLACE IF NECESSARY
COMPLETE TUNE-UP PERFORMED BY AN AUTHORIZED YETI DEALER
SCHEDULE
30003005 SHCS M61.0 20L, SWITCH LIN MONT 12
300040486 COLLET WEDE BOLT, SMALL 8
300030151 BOLT, TI MALE, M6 X 1.0 

Yeti SB150 Specifications

General

Rear Travel	150mm
Frame Material	Carbon Fiber
Suspension	Full Suspension
Intended Use	Enduro
Brakes	Hydraulic Disc
Drivetrain	Varies by build kit (Shimano or SRAM)