Need help?Do you have a question about the Yeti SB6C and is the answer not in the manual?
General| Frame Material | Carbon Fiber |
|---|---|
| Wheel Size | 27.5" |
| Front Travel | 160 mm |
| Brake Type | Hydraulic Disc |
| Handlebar | Yeti Carbon |
| Tires | Maxxis Minion DHF/DHR II |
| Rear Shock | Fox Float X2 |
| Fork | Fox 36 |
| Brakes | SRAM Guide RSC |
| Stem | Race Face Turbine |
Patented suspension system for efficient pedaling and smooth riding.
Provides a stiff, strong, and lightweight chassis for the bicycle.
Creates a stiff frame interface with Enduro Max sealed bearings for smooth pivot movement.
Built-in system for chain guide options, lighter than conventional tabs.
Allows for a larger head tube, increasing stiffness and lowering ride height.
Features a Fox Float-X shock with 8.5-inch eye-to-eye and 2.5-inch stroke.
Guards on seat stay and chain stay keep the bike quiet and protect the frame.
Internal routing for clean, protected cables, resulting in a cleaner looking bike.
Removable mount designed for Shimano side-swing front derailleurs.
Boost 148 dropouts provide strength, stiffness, and ease of wheel installation.
Guides rider sizing based on height for optimal bicycle fit.
Provides a list of recommended maintenance tasks and their frequencies.
Recommends using a torque wrench and lists key torque specifications for assembly.
Details on setting the main air spring pressure to achieve proper sag.
Instructions on measuring sag to ensure correct shock setup for the bike.
Guide to adjusting shock rebound and compression settings for optimal performance.
Instructions for preparing and installing the derailleur hanger onto the frame.
Guidance on installing the hanger cap, noting its reverse threading.
Details on properly tightening the hanger cap using a specific torque.
Explains how to route the rear brake housing through the swing arm.
Details on routing the rear shift housing from the swing arm to the derailleur.
Instructions for routing the dropper post housing through the frame's upper port.
Steps for applying Loctite, installing washers, and seating the Infinity Link.
Details on installing the main pivot pin and holding the link in place.
Instructions for inserting the lower pivot pin, washer, and grease.
Guide to aligning and attaching the swingarm with the main pivot pin.
Steps for installing the rear shock using guide pins and hardware.
Final torque sequence for shock mounting hardware on both ends.
Instructions for final tightening of main pivot and upper link axles.
Comprehensive kit for rebuilding the SB6c, including bearings and hardware.
Kit containing essential hardware components for the SB6c.
Specific kit for the front derailleur mounting system.
Kit containing replacement bearings for the SB6c.
Kit containing protective parts for the SB6c frame.
Kit for the SB6-C cable guide system.
Details the terms of the five-year limited warranty for the frame.
Outlines conditions that limit warranty coverage, such as wear and tear or misuse.
Explains Yeti's policy for replacement parts in non-warranty situations like crashes.
Discusses the expected lifespan of a frameset and recommends annual inspection.
States Yeti Cycles' liability limitations regarding bike use and damage.
To Next Page
