YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World!
YMGI: Your Modern Green Idea
41
The SHORT CUT function will not store parameters of TIMER, CLOCK or HOLD
MY TEMP
The MY TEMP button is used to set or cancel the MY TEMP Function. When set, the MY TEMP function means that the
remote will transfer the temperature where it is set at the moment. While running, the system will work to keep the area
near the remote at the temperature that was recorded the MY TEMP function was turned on.
SLEEP
The SLEEP button is used to set or cancel the Sleep Function. When set, the SLEEP function will switch the fan speed to
low, but you can set the fan speed to Medium or High speeds. If the TURBO function is set, the SLEEP function will be
cancelled.
°C /°F
The °C/ °F button is used to switch between Fahrenheit and Celsius temperature display on the remote control.
Energy-saving function
Under cooling mode, press "TEMP" and "CLOCK" buttons simultaneously to start up or turn off energy-saving function.
When energy-saving function is started up, "SE" will be displayed on the remote controller, and air conditioner will adjust
the set temperature automatically according to factory settings to reach to the best energy-saving effect. Press "TEMP"
and "CLOCK" buttons simultaneously again to exit energy-saving function.
Note:
Under energy-saving function, fan speed is defaulted to auto speed and it cannot be adjusted.
Under energy-saving function, set temperature cannot be adjusted. Press "TURBO" button and the remote
controller won’t send signal.
Sleep function and energy-saving function can’t operate at the same time. If energy-saving function has been set
under cooling mode, pressing the sleep button will cancel energy-saving function. If sleep function has been set
under cooling mode, starting the energy-saving function will cancel sleep function.
Operation Guide
1. After turning on the power at the fuse box, press "ON/OFF" button on remote control to turn on the air conditioner.
2. Press "MODE" button to select your required mode: AUTO, COOL, DRY, FAN, HEAT.
3. Press " " or " " button to set your required temperature. (Temperature can’t be adjusted under auto mode).
4. Press "FAN" button to set your required fan speed: auto, low, medium and high speed.
5. Press "SWING" button to select fan blowing angle.
NOTICE
To Next Page
Loading...
Need help?
General
