Yoder Smokers YS640 User Manual

25
Yoder YS 640
2. Reach into the hopper cavity on the left side of the igniter tube and pull the igniter
wires into the rebox.
3. Unplug the igniter’s weather tight connection and then push the wires back into the
hopper cavity.
TO CONTROL BOX
TO IGNITER IN
COOKING CHAMBER
4. Reinstall the burn grate and place a small handful of pellets onto the grate.
5. Light the pellets with a torch, starter gel or starter stick.
6. Once lit, turn the power switch to the “on” position and press start on the control
panel:
• The feed system begins the prime cycle before defaulting to the set tempera-
ture feed rate.
• Set the desired cooking temperature (default set point is 350° F).
• Your smoker will begin to produce a smoke during “startup” within approxi-
mately 3 to 5 minutes. To check if the pellets ignited, open the smoker and a
ame should be visible in the burn pot area. You will be able to view this with-
out having to touch any hot surfaces.
FIG 21

Yoder Smokers YS640 Specifications

General

Brand	Yoder Smokers
Model	YS640
Category	Grill
Language	English