YOKOGAWA Daqstation DX2020

7-7
IM 04L42B01-01E
Customizing Actions Using the Event Action and Remote Control Functions (/R1 and /PM1 Options)
1
2
3
4
5
6
7
8
9
10
11
12
13
App
Index
7.2 SetupExamplesofEventAction
Example1:Starting/StoppingtheMemorySamplingthroughRemoteControl
(/R1Option)
Starts/Stops the memory sampling when a signal is applied to remote control input
terminal 2. Use logic box number 1.
• SetupScreenandSetupItems
Press MENU (to switch to setting mode), and select the Menu tab > Timer,Event
action > Eventaction.
<Operation>
If the input to the remote control input terminal 2 is turned ON when memory sampling
is stopped, memory sampling starts. If the remote control input is turned OFF when
memory sampling is in progress, memory sampling stops.
Example2:WritingaMessageWhenanAlarmOccurs
Write the message “Channel 1 Alarm” to group 1 when an alarm occurs on channel 1.
Use logic box number 2.
• SetupScreenandSetupItems
Press MENU (to switch to setting mode), and select the Menu tab > Timer,Event
action > Eventaction.
<OtherSettings>
• Setanalarmtochannel1andoutputtointernalswitch3.
• Register“Channel1Alarm”inmessagenumber4.
For the procedure to set the alarm, see section 3.7.
For the procedure to set the message, see section 5.4.