YOKOGAWA Daqstation DX2048 - Page 176

4-44
IM 04L42B01-01E
• ExpandingOneofthePanelstoFullScreen
1.
Press DISP/ENTER.
The title bar of one of the panels turns dark blue.
2.
Select the panel you wish to expand using the arrowkeys (the panel of which the
title bar is dark blue is the selected panel).
3.
Press DISP/ENTER to show the display selection menu.
4.
Press the rightarrowkeyto show the sub menu.
5.
Press the upanddownarrowkeys to select EXPAND.
* To showEXPANDon the screen menu, see section 5.18.
Select EXPAND
This
EXPAND
is not shown under the initial conditions. To show, operate as follows:
Press
MENU and select Menu customize > Display menu. Set EXPAND on the
display menu to
View.
For the operating procedure, see section 5.18.
6.
Press DISP/ENTER to expand the specified panel.
To close the menu without expanding the screen, press
ESC
.
• ChangingtheNameoftheFourPanelDisplay
If you change the name of a four panel display, the specified name appears in the
display menu.
Carry out the following procedure when the four panel display is shown.
1.
Press FUNC to display the FUNC key menu.
2.
Press the 4Panel soft key to display a list of four panel names.
3.
Press any of the 4Panel1 to 4panel4 soft keys to display a window used to enter
the display name.
4.
Enter the display name (up to 16 characters,
A a # 1
)
5.
Press DISP/ENTER to activate the specified display name and return to the four
panel display.
To cancel the change, press
ESC
.
4.10ShowingtheFourPanelDisplay