iv
TI 32S01J30-01E
Considerations for Using This Product in Safety
Power Supply Wiring
WARNING
The connection of power cables and the selection of power cables must be done in accordance
with this book and the Installation Guidance, and implement so as to comply with the standards
and laws about explosion protection in the country or the area where the cables are laid.
Ground Wiring
WARNING
You should implement so as to comply with the standards and laws about explosion protection in
the country or the area where the cables are laid.
Input/Output Wiring
CAUTION
• The connection of input and output should be done in accordance with this book and the
Installation Guidance, and implement so as to comply with the standards and laws about
explosion protection in the country or the area where the cables are laid.
• Wiring material and device which is electrically connected to this equipment should be
products that complied with standards and laws about explosion protection in the country or
the area where the cables are laid.
Tightening Torque of Screws
IMPORTANT
The tightening torque that the Product recommends is showed in the following table. However,
if the tightening torque of the screw is specied in the User’s Manuals, follow the instructions
described in the User’s Manuals.
Table Table of Recommended Tightening Torque
Nominal diameter of a screw M2.6 M3 M3.5 M4 M5 M6 M8 M10
Recommended tightening torque
(N•m)
0.35 0.6 0.8 1.2 2.8 3.0 12.0 24.0
Dec. 3, 2021-00
To Next Page
Loading...