YOKOGAWA Sushi Sensor - Introduction

1
TI 01W06A51-50EN
Mar.26,2019-00
Introduction
This document describes how to install and set up a LoRaWAN gateway to be used in a Sushi
Sensor system.
This document is intended for systems in which MultiConnect Conduit IP67 Base Station
manufactured by Multi-Tech Systems is used as a LoRaWAN gateway (hereinafter referred to as
“gateway”).
This document does not contain any information related to services.
 Notes Regarding this Document
• Thisdocumentisintendedforrmwareversion1.6.4ofMultiConnectConduitIP67Base
Station manufactured by Multi-Tech Systems. When the version is upgraded, the screen
layout and setup procedures may be changed from those of the previous version.
• Thecontentsofthismanualaresubjecttochangewithoutpriornotice.
• Allrightsreserved.Nopartofthismanualmaybereproducedinanyformwithout
Yokogawa’s written permission.
• Ifanyquestionarisesorerrorsarefound,orifanyinformationismissingfromthismanual,
pleaseinformthenearestYokogawasalesofce.
CAUTION
Indicates a potentially hazardous situation which, if not avoided, may result in minor or
moderateinjuryorphysicaldamage.Itmayalsobeusedtoalertagainstunsafepractices.
IMPORTANT
Indicates that operating the hardware or software in this manner may damage it or lead to
system failure.
NOTE
Draws attention to information essential for understanding the operation and features.
All Rights Reserved, Copyright © 2019, Yokogawa Electric Corporation