IM 05C01E12-41E
12
CAUTION
To prevent electric shock, the controller should be mounted on the panel so that you do not accidentally
touch the terminals when power is being applied.
NOTE
The temperature controller is shipped with the parameters set at the factory-set defaults. Check the default
values against the “Parameter Lists” in the following page (P.14, 15), and change the parameter settings
that need to be changed.
This section explains how to set and register parameter values.
The procedure for changing SP (target setpoint) and A1 (alarm 1 setpoint) can be found on “Changing Target
Setpoint (SP)” and “Changing Alarm 1 Setpoint (A1),” respectively. You can set the other parameters in the same
way.
There are no setup displays for parameters specific to functions, such as the optional alarm output functions or
heating/cooling control, if they were not selected at ordering.
The setting of some parameters (such as the control mode parameter CTL) determines whether the other param-
eters are displayed or not.
The flowchart (P.13) will help you understand how this works.
To Next Page
Loading...
Need help?
General
